Lessons Learned About

Methods of Installing Attic Fans

There are hooter days than the rests of the days. Such conditions call for the need of attic fans. A lot of cooling to the homes is brought about by the attic fans. Some people can hire specialists to install the fans for them. Some methods may not require so much money as when the experts are used. You can install an attic fan on your own without the help of the specialists. You can get a lot of money that you would rather have spent on the specialists. Reading below you will get some of the tips to fuse in mounting the fans.

There is always the need to inspect your vent before installing a fan. One way of inspection is by taking measurements by a thermometer on hotter days. This will help in knowing whether your fan gets enough ventilation. You also need to decide on the fan that you want to install. Attic fans exist in two types. That is the roof fans and the gable fans.

The measurements are needed to make the installation. The measurements will give you the best size of the fan that you wish to mount. You need to measure to allow you do the calculations. The cubic feet of air that is moved out per minute help in the measurement of the fans. You can know the fan that you need by squaring the feet that’s you get. 0.7 is used to multiply the answer that is received after squaring. Whatever you get is the CFM if the fan that you may need.

The second way to install an attic fan is to remove the old shutter. If the fan is bigger than the vent then you need to do away with the vent. You then have to place the new fan over the hole of the older vent. Here again you are required to measure before you do any cutting. The vents should be accommodating enough. The cuttings should enable the fan to fit very well in the hole. You also need to make sure that there are no vent framing when cutting.

Mounting the fan may be the last step in installing an attic fan. Here there should be a piece of plywood that should be used in the mounting. There are framing around the hole where the plywood should be fixed too. To place the whole directly above that which is made by the vent, you will have to fix the plywood on the walls. A jigsaw may be used to cut. Then you can tighten it with the screws. There should be a proper alignment of the fans.

In conclusion, the attic fan is very easy to install, and you may not need help from professionals to mount it.

Comments are closed.